Adjusting The Near-End Sensor - Star TSP800-Serie Bedienungsanleitung

6. Adjusting the Near-end Sensor

Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
1 Open the printer cover.
2 Determine the diameter of the roll paper you are using and find the required
setting in the table below.
3 Insert the tip of a ballpoint pen or similar pointer object into the hole of the
adjuster. While pressing the adjuster, slide it up or down to the setting that
matches the roll paper you are using.
Make sure the tab indicated by the arrow in the illustration is inside one of the
grooves.
Level 1
Level 2
Level 3
All manuals and user guides at all-guides.com
– 16 –