Electrical Connection; Instructions For Use - EUROM OK22T Handbuch

 If you can, use 1-K paraffin in this heater. Other premium quality paraffin may also
be used.

Electrical connection

Before use, check the device and the electrical cable, plug and socket for any
damage or wear and tear and do not use if you discover any problems.
This heater is fitted with a standard 230V - 13A plug. Choose an impact-resistant
type if it ever needs replacing. The electricity network to which the heater is
connected must be equipped with an earth leakage circuit breaker (30 mA) and the
socket must be earthed.
Repairs to the electrical system must always be carried out by a qualified electrician!
 Before use, always check that the socket is of the correct voltage, is earthed, has
an adequate fuse (5A) and forms part of a mains network with an earth leakage
circuit breaker.
 If you have to use an extension cable, make sure that the cable is of a suitable
width which is appropriate for the voltage and amperage.

Instructions for use

Starting the heater:
 Place the heater on a stable, flat and horizontal surface.
 Remove the tank cap.
 Fill the tank with paraffin or diesel.
 Replace the cap on the tank.
Note: Never replenish fuel if the heater is on or is still hot. Always wait until the
heater has cooled down before topping up the fuel.
Never fill up the fuel in an enclosed area; always do it outdoors.
Do not overfill the heater and remove any spilt fuel immediately, before using the
heater.
 Now insert the plug into the socket.
 Set the thermostat to the desired setting.
 Press the ON/OFF switch to ON. The light will come on and the heater will start.
Important: Ignite the heater for the first time outdoors and then let it run for at least
10 minutes. Oil and similar substances used during the manufacturing process will be
burnt off and may produce toxic gases.
If the heater won't start, the thermostat regulator may be set too low. Turn the
thermostat button up and try again. If it still doesn't start, set the switch to OFF and
then switch back to ON.
41