Installation And Connection; Operating - EUROM Hot Shot 2000 Wifi Gebrauchsanleitung

Remote control
7. Temperature higher
8. MODE button
-
Ventilate (LED ring goes blue)
-
Low power heating (1000 W) (LED ring
goes green)
-
High power heating (2000 W) (LED ring
goes red)
9. ECO setting, the thermostat is set to 16°C
10. Temperature lower
11. 3 colour LED ring ON/OFF
12. ON/OFF button
13. Oscillate

Installation and Connection


Remove the packaging materials and keep out of the reach of children. After removing
packaging, check device for damage or any evidence that may point to a defect/failure.
If in doubt, do not use the device but refer to your supplier for checks/repairs.

Choose a suitable place for the device, taking into account all warnings mentioned
previously in these instructions.

Check whether the Main switch is set to OFF (O).

Unroll the electrical cable entirely and insert the plug into a suitable 220-240V socket:
In order to avoid an overload, make sure no other devices are connected to the same
group.
 Switch the heater on by setting the main switch to I (ON). The heater is now in stand-
by.
 The heater can now be operated manually, with a remote control or with an app.

Operating

Operation using heater panel (manual) and remote control
1. Press on the button
temperature. The thermostat starts on 21°C and high power heating, LED ring is red
and there are 3 dots on the display.
NB: if the ambient temperature is lower than 21°C, the heater will heat for a while at
full power. If the ambient temperature is higher than 21°C, the heater will start to
ventilate.
2. Press the button
the display shows:

1 dot (just ventilate),

2 dots (low power heating)

3 dots (high power heating)
to start the heater. The display shows the ambient
to change the mode, each time you press the button
31