Transport And Storage; Assembly And Installation - EUROM Rad 1000 Oil free Bedienungsanleitung

Transport and storage

•
Clean the device before storing it.
•
Transport the device upright.
•
Store the device upright in its original packaging in a cool, dry and dust-free area.

Assembly and installation

The device is packed in one box. Remove all packaging material and check that the device is
not damaged. Do not use the heater if it is damaged, but always contact your supplier. Keep
the packaging for safe storage and transport.
Assembly
1. Lay the device down on a steady soft surface
(Figure 4, pos. 4).
2. Place the pedestals (Figure 4, pos. 3) on both
sides of the main body (Figure 4, pos. 5).
3. Screw and tighten the pedestals with two
screws (Figure 4, pos. 1) using a Phillips
screwdriver (Figure 4, pos. 2).
Installation
WARNING
Do not use an extension cable, this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 1000 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
14
Figure 4