EUROM Hot Shot 2000 Wifi Gebrauchsanleitung Seite 30

from the socket immediately. Take the entire device back to your supplier or a
recognised electrician to be checked and/or repaired. Always ask for original parts to
be used.
4. The device may only be opened and/or repaired by a competent and qualified
person. Do not carry our your own repairs as this could be dangerous! Repairs carried
out by unauthorised persons or changes made to the device could damage the
dust/waterproof capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the manufacturer, their
service department or somebody with similar qualifications in order to prevent
creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
Heater
A. Main switch ON/OFF (back)
B. Air output grille
C. Display
D. Operating panel buttons
E. Handle (back)
F. Remote control
Operation panel
1. Temperature higher
2. Temperature lower
3. ON/OFF button
4. MODE button
-
Ventilate (LED ring goes blue)
-
Low power heating (1000 W)
(LED ring goes green)
-
High power heating (2000 W)
(LED ring goes red)
-
Hold ECO setting in for 5
seconds, the ECO setting will
set the thermostat to 16°C.
5. Oscillate
6. LED ring
30