EUROM OK22T Handbuch Seite 39

Assembly OK37T
This model is equipped with wheels and push-bars. Wheels, push-bars and assembly
materials can be found in the packaging.
 Slide the axle through the wheel support-frame.
 Secure the wheels to the axle, so
that the wheels' bulged hubs face
towards the frame.
 Place the flat rings over the axle
ends, push the split pins with the
long ends through the hole in the
axle and push them tight.
 Place the heater on the wheel
support-frame so that the air inlet
(at the back) is positioned over the
wheels.
 Line up the holes in the fuel tank
flange with the holes in the frame.
 Place the push bars over the fuel
tank flange.
 Stick the screws through the push
bar, the fuel tank flange and the
wheel support-frame (see diagram)
and hand-tighten a nut under each screw.
 Once all screws are in place, tighten all nuts with a spanner.
Assembly OK63T
This model is supplied with fitted push bars
and an adjustable stand. You only need to
mount the wheels with the axle and the
supports, see diagram.
39