10. Always unplug the machine from the electrical outlet when removing
covers, when lubricating or when making any other user servicing
adjustments mentioned in the instruction manual.
11. Never drop or insert any object into any opening.
12. Do not use outdoors.
13. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
14. To disconnect, turn all controls to the off ("O") position, then remove plug
from outlet.
15. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
16. Basically, the machine should be disconnected from the electricity supply
when not in use.
17. If the power cord of this appliance is damaged, it must be replaced with a
special cord by your nearest authorized dealer or service center.
18. (Except USA/Canada) This machine is provided with double insulation.
Use only identical replacement parts. See instructions for servicing Double-
Insulated machine.
19. When you sew slowly for long time, machine will have heat or unusual
smell occurs. In this case, disconnect the plug from the wall outlet and use
it after a while. Contact your nearest dealer if it still occurs.
20. Don't use the machine if it's wet or in humid environment.
21.
The sewing machine is equipped with a LED lamp. If the LED lamp is
broken, it must be replaced by the manufacturer or its service agent in
order to avoid a hazard.
22. Never place anything on the foot control.
23. The machine must only be used with foot controller type
24.
The sound pressure level under normal operating conditions is 75dB(A).
25.
Keep the instruction at a suitable place that close to the machine, and hand
it over if you give the machine to a third party.
"SERVICING DOUBLE-INSULATED PRODUCTS
(Except USA / Canada)"
In a double-insulated product, two systems of insulation are provided instead of grounding. No
grounding means is provided on a double-insulated product nor should a means for grounding be
added to the product. Servicing a double-insulated product requires extreme care and knowledge
of the system and should only be done by qualified service personnel. Replacement parts for a
double-insulated product must be identical to those parts in the product. A double-insulated product
is marked with the words DOUBLE INSULATION or DOUBLE INSULATED.
The symbol
may also be marked on the product.
All manuals and user guides at all-guides.com
3
KD-2902/FC-2902D.