I Troubleshooti Ng The Connecti On To The Iaqualink™ App - Zodiac RV 5480 iQ Montage- Und Gebrauchsanleitung

6.3 I Troubleshooti ng the connecti on to the iAquaLink™ app
• Before you connect to a new Wi-Fi network, re-initi alise the parameters of your current Wi-Fi network or simply
change the Wi-Fi password. You will have to re-make the connecti on between the control unit and the new Wi-Fi
network, see "4.2 I First-ti me cleaner confi gurati on".
Control unit status
• Bright sunlight
• Control unit
• All LEDs are off
• Power cut
• Internet connecti on
• Internet connecti on
• LAN / WEB LEDs
are off
• Weak Wi-Fi signal*
• LAN / WEB LEDs
are on but the Wi-Fi
network is non-
existent (or spott y).
The "Connecti on
Error" message
is displayed on • The control unit is too
the screen in the
iAquaLink™ app.
• The smartphone may
• LAN/WEB LEDs
are on but the
connecti on is
unsuccessful.
All manuals and user guides at all-guides.com
Possible causes
• Shield the lights to block sunlight and check again whether the
lights are lit.
• Connect the control unit (see "3.4 I
disconnected connecti ons").
• Check that there is power to the circuit breaker.
• Check that there is power to the socket by connecti ng another
device to it.
• Check the internet connecti on - Network may be down.
lost
• Check the internet connecti on - Network may be low.
• Ensure that you have a suffi ciently strong Wi-Fi signal. There
lost
are several ways to check the strength of the Wi-Fi signal:
• On fi rst set-up, Move the control unit closer to the home Wi-
Fi router. Do not use an extension lead (see "3.4 I Electrical
supply connecti ons"), then repeat the confi gurati on steps (see
"4.2 I First-ti me cleaner confi gurati on") :
far from the home Wi-
Fi network
• If the smartphone is sti ll connected to the
not have properly
"Roboti cCleaner-***" Wi-Fi, manually disconnect the
disconnected from the
"Roboti cCleaner-***" Wi-Fi.
"Roboti cCleaner-***"
• Then, if connecti on is not made automati cally, manually
Wi-Fi in order to
connect the smartphone to the home Wi-Fi or 3G or 4G
reconnect to the
network.
home Wi-Fi or to the
3G or 4G network.
Soluti ons
- Unplug the home Wi-Fi router, then plug it back in.
- Using a portable computer, go into Confi gurati on Panel
to see the state of your network connecti ons. Check the
strength of the wireless network Wi-Fi signal on the portable
computer while looking at the control unit.
- Install the iAquaLink™ app, using a smartphone or tablet.
Check the strength of the wireless network Wi-Fi signal on
the mobile device while looking at the control unit. If the
Wi-Fi network is weak, install a Wi-Fi extender.Uti liser une
applicati on dédiée à l'analyse Wi-Fi : il en existe plusieurs
dans iOS ou Android.
- Once the LAN/WEB LEDs light up, plug in the control box
near the pool.
- If the LAN/WEB LEDs do not light up, plug in the control box
again as close to the house as possible.
- If the LAN/WEB LEDs sti ll do not light up, install a Wi-Fi
extender.
Electrical supply
EN
23