Truma Mover S M2 Gebrauchsanweisung Seite 18

Bolt drive units with lateral bar to mounting set using U-bracket
(d), tight enough so that it can just about be moved.
d
Washer 10
(16 x)
Self-locking
nut M10 (8 x)
Position the drive rollers so that they are at approximately the
same height as the wheel hub (middle of wheel ± 30 mm).
Truma can supply a spacer plate set for compensating for
height differences of up to 45 mm (part no. 60010-66000,
2 pcs. à 15 mm). Up to three spacer plates can be used at
each side. A bolt set (part no. 60010-70000) is needed to
attach the spacer plates.
The flat frame mounting set (Part. no. 60010-64900) must be
used for height differences of more than 45 mm. Check that
there is adequate ground clearance (min. 110 mm).
The correct distance can be set between the tyre and the
roller (20 mm) with the provided spacer by sliding the (swiv-
elled out) drive units in the longitudinal direction. The movable
middle tube makes it possible to adapt to the width of the frame.
18
M10 x 50 (8 x)
± 30 mm
min. 110 mm
20 mm
min. 110 mm
Slide drive units in lateral direction so that the maximum
amount of tyre tread is covered.
Ensure that there is adequate
clearance between the gearbox
and the tyre / shock absorber
so that they do not touch.
The minimum clearance
with the drive units
swivelled in is 10 mm.
After correctly positioning the bolts and nuts of the mounting
set, tighten slightly and then check the required distances /
clearances again. The weight of the caravan must be on the
wheels when doing this.
Move sliding middle tube to a central position (e.g. measure
at open side of middle tube with a pocket rule), tighten the
4 bolts (15 – 20 Nm) and secure the locknuts.
Re-check the distance of 20 mm
to the tyre (with weight on wheels)
and then tighten the 2 mounting set
bolts (M8) with 20 Nm and the
4 mounting set bolts (M10) with
40 Nm.
The bolt tightening order must be
strictly adhered to for correct
installation.
Re-check that all 6 bolts have been tightened to the
correct torque!
Fit covering plates:
Place covering plate onto housing and fix in position with
3 guide pins in each case (knock in with a hammer or
screwdriver handle).
Installing the position
indicator:
Push the position
indicator into the two
holes in the gearbox.
min.
10 mm
20 Nm
40 Nm
40 Nm