DE
EN
1. Push the fin (1) into the slot provided for it.
2. Tighten the three aluminium bolts (2) to 2 Nm torque.
3. Check that the aluminium bolts (2) are tightly seated.
Installation of propeller
1
Shaft anode
2
Cotter pin
3
Castle nut
1. Push the axial thrust washer onto the shaft, with the chamfer towards the motor.
2. Push the propeller onto the shaft as far as it will go.
3. Place the washer (4) in between, and then fit the crown nut (3) (SW 24 ratchet).
4. Tighten the crown nut (3) to 5 Nm torque, and further tighten this until the slots
of the crown nut (3) and bore are superimposed.
5. Push in a new cotter pin (2), and secure it.
6. Screw on the shaft anode (1) (10 Nm torque).
5.3
Connection of remote steering
page 76 / 113
4
Washer
5
Axial thrust washer
Startup