Selecting Automatic Tracking; Selecting / Cancelling Direct Programming; Switching Mute On/Off; Interrupting Tp Announcements - JVC KD-NX10 Bedienungsanleitung

Selecting automatic tracking

In all modes and wavebands, automatic
tracking can be turned on by pressing
and holding the button for more
than 2 seconds.
In the TP menu:
Press multifunction button
peatedly until TP on appears.
Attention:
If a TP station has already been pro-
grammed directly, it will once again be
selected as the TP station.
Selecting / cancelling direct
programming
Switching on TP menu.
Selecting:
Press the multifunction button.
Using the right rotary control
re-
lect the desired TP station and press to
confirm.
After a short delay and without actua-
tion, the selected station is accepted.
Cancelling:
Press the multifunction button.
Select Autoselect
rotary control and press the control
to confirm.
After a short delay and without actua-
tion, direct programming is cancelled.

Switching mute on/off

After selection of a TP or Enhanced
Other Networks station, the mute
function can be activated by pressing
the
Thereafter, only traffic announcements
and navigation announcements will be
switched through.
, se-
The mute function is cancelled by
pressing the
Interrupting TP announce-
ments
An announcement
broadcast can be interrupted.
Briefly press the
the TP announcement.
The unit switches back to the previously
selected mode.
with the right
Radio operation
button briefly.
button again.
currently being
button during
157