Maintenance; Adjusting The Belt - BH FITNESS G6180i Montage- Und Gebrauchsanleitung

MOVEMENT & STORAGE.-
The unit is equipped with wheels (64),
Fig.6 to make it easier to move. Make
sure that the mains cable is unplugged
from the wall socket.
If you wish to move the treadmill, the
first thing to do is to fold it up, place
your hands on the handrails (G & H)
and tilt the treadmill, Fig.6, so that the
wheels (64) rest on the floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.

MAINTENANCE.-

Use the bottle of lubricant (108) to
lubricate the inside of the belt in order to
keep your unit in top condition and to
ensure that friction between the belt and
the board Fig.7 is kept to a minimum
(due to different running styles, always
apply more lubrication to the area where
you place your feet during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
Hours per week
<=7
<6 1
month
>6 2
months
Note: This preventive
schedule is only meant for home use.
In aggressive environments, with high
dispersion of particles or with heavy
weight people, lubrication
should be increased accordingly.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
CAUTION:
supplied by BH or lack of lubrication
leads to loss of warranty.

ADJUSTING THE BELT.-

If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways. If the belt does shift to the left
or right, stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt,
set the unit in motion at a speed of
4km/h. If the belt has moved to the right,
turn screw (R) on the right-hand side of
the machine a 1⁄4 turn clockwise. Note
the position of the belt, if after one minute
the belt is not completely centred then
repeat the operation. If you see that the
belt has moved too far over to the left
>7
then turn the right screw back slightly in
1 month
an anticlockwise direction. Fig.8.
As soon as you have adjusted the belt
1 month
you can begin exercising again.
maintenance
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn clockwise.
frequency
Note the position of the belt, if after one
minute the belt is not completely centred
then repeat the operation.
If you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction. Fig.8.
17
Using lubricant not