Maintenance; Adjusting The Belt - BH FITNESS i.F9R Dual Montage- Und Gebrauchsanleitung

When folding or unfolding the treadmill
make sure that there are no children
about or obstacles that might hinder
the folding motion.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (64),
Fig.6 to make it easier to move. Make
sure that the mains cable is unplugged
from the wall socket.
If you wish to move the treadmill, the
first thing to do is to fold it up, place
your hands on the handrails (G & H)
and tilt the treadmill, Fig.6, so that the
wheels (64) rest on the floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.

MAINTENANCE.-

Use the bottle of lubricant (10) to
lubricate the inside of the belt in order to
keep your unit in top condition and to
ensure that friction between the belt and
the board Fig.7 is kept to a minimum
(due to different running styles, always
apply more lubrication to the area where
you place your feet during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is used.
<3
<6
1 year
6-12
6
month
s
>12
3
month
s
Note: This preventive
schedule is only meant for home use.
In aggressive environments, with high
dispersion of particles or with heavy
weight people,
should be increased accordingly.
Hours per week
3-7 >7
6 3
months months
3 2
months months
2 1
months month
maintenance
lubrication frequency
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
CAUTION:
supplied by BH or lack of lubrication
leads to loss of warranty.

ADJUSTING THE BELT.-

If your unit is not seated evenly on the four
contact points, this may cause the belt (X)
to shift sideways. Rigorous quality control
adjusts and checks the running belt.
However, due to weight differences and
individual styles of running, the belt may
be prone to shift sideways.
If the belt does shift to the left or right, stop
the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt, set
the unit in motion at a speed of 4km/h. If
the belt has moved to the right, turn screw
(R) on the right-hand side of the machine
a 1⁄4 turn clockwise. Note the position of
the belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn the
right screw
anticlockwise direction. Fig.8.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise. Note the position of the belt,
if after one minute the belt is not
17
Using lubricant
back slightly
not
in an