Enraf Nonius EN-Dynamic Gebrauchsanweisung Seite 40

Chip card
To execute a training programmed on an EN-
Train or Track chipcard, simply put the card
into the opening at the top of the console
(chip facing down and towards you).
The device will show a welcome screen.
Press OK to start the training.
If the training is completed, a beep will sound
and the device will tell you where to go next
(next device or PC).
Remove chipcard.
General hardware operation
Many parts of the EN-Dynamic equipment can be changed in position. They are fixed by means of a
fixation button. Be sure that the fixation button is well fixed. This means that the spring-button is not
extended from the knob (see picture).
✔
Page 12 of 26
✘
EN109-1412791-48 IFU