Planning The Installation; Tools Required For Installation; Installation Example - Motorola solutions WAVE Mobile TLK 150 Installationsanleitung

Chapter 4
Installation Details for Standard
Configurations
The mobile radio operates only in negative ground electrical systems.
Before starting the radio installation, make sure that the ground polarity of the vehicle is correct.
Accidentally reversing the polarity will not damage the radio, but will cause the cable fuses to blow.
4.1

Planning the Installation

Planning is the key to fast, easy radio installation. Before starting the installation, inspect the vehicle
and determine how and where you intend to mount the antenna, radio, and accessories.
Plan wire and cable runs to provide maximum protection from pinching, crushing, and overheating.
CAUTION:
Before installing any electrical equipment, check the vehicle manufacturer user manual for
warnings or recommendations.
The installation of this device should be completed by an authorized servicer or installer. Failure
to properly install the device may result in damage to the device, or improper operation.
4.1.1

Tools Required for Installation

The following table shows the tools required for installation.
• Rubber-coated pliers
• Regular slot screwdriver or Phillips #2
• Pin removal tool
• ¼ hex driver
• 11/32 hex driver
4.1.2

Installation Example

The mobile two-way radio offers various methods of installation, with accessories placed to the vehicle
as desired.
The radio can only be installed in a dash mount configuration.
Installation Details for Standard Configurations
MN007262A01-AD
13