Removing The Fpa15 Board; Fitting The Fpa15 Board - Fronius Transpocket 1500 Erdstrom Serviceanleitung, Ersatzteilliste

Removing the
FPA15 board
(continued)
Fig.9
Fitting the FPA15
board
- TP 1500 RC / 1500 TIG: Apply a thin layer of lubricant to the seal of the remote-
control socket (7) (Fig.10)
- TP 1500 RC / 1500 TIG: Apply gentle pressure to the seal of the remote-control
socket (7), to prevent it being forced out when you press on the FPA15 board
- Snap the FPA15 board (5) onto the rear alignment pin first
Fig.10
Fig.11
Fig.12
Note! Before fixing the FPA15 board (5) on the alignment pins, do the following:
(69) (70)
Fig.13
71
- Swing the copper bracket (55) to one
side
Note! First carefully detach the
FPA15 board (5) from the front
alignment pins.
(5)
- Carefully lift the FPA15 board (5) and
remove it
(7)
(55)
- Carefully press the FPA15 board until
all the alignment pins have snapped
into place
(7)
- Swing the copper bracket (55) back
into its original position
(55)
- TP 1500 TIG: Tighten the hexagon nut
(69) (width-across=13) for the screw-
fixing of the
- TP 1500 / 1500 RC: In the
tighten the M5x12 (TX20) screw (70)
socket
socket,