Adjusting The Skids; Operating With The Overheat Sensor - Toro Z Master Professional 7500-D-Serie Bedienungsanleitung

Adjusting the Skids

Mount the skids in the lower position when operating
at heights of cut greater than 51 mm (2 inches) and
in a higher position when operating at heights of cut
lower than 51 mm (2 inches).
Adjust the skids as shown in Figure 28.
g035646
Figure 28
Operating with the Overheat
Sensor
The PTO disengages, an alarm sounds, and a
bar graph displays the engine temperature when it
reaches an overheat condition. The PTO does not
engage until the engine has cooled and you manually
shut off the PTO and engage it.
Note:
If the engine-coolant level is below the indicator
line on the overflow bottle when the engine is cold, the
coolant temperature gauge may not register correctly
during operation and/or the audible alarm may not
sound if the engine overheats.
29