Using The Side Discharge; Adjusting The Height Of Cut - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Using the Side Discharge

Machines with Side Discharge
Only
The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
• Never remove the grass deflector from the
mower deck because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower deck.
• Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
position, rotate the key switch to the O
position, and remove the key from the key
switch.
• Make sure that the grass deflector is in the
down position.

Adjusting the Height of Cut

Adjust the height of cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Raise the height-of-cut lever to the T
position (also the 127 mm (5 inch) cutting-height
position)
1. Height-of-cut lever
2. To adjust, remove the pin from the height-of-cut
bracket
FF
3. Select a hole in the height-of-cut bracket
FF
corresponding to the height of cut desired, and
insert the pin
4. Move the lever to the selected height.
29
(Figure 28).
Figure 28
2. Pin
(Figure 28).
(Figure 28).
RANSPORT
g009568