Controls System Maintenance; Adjusting The Control Handle Neutral Position - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Figure 91
1. Mounting bolt
3. Increase or decrease the alternator-belt tension.
4. Tighten the mounting bolts.
5. Check the deflection of the belt again to ensure
that the tension is correct.
g008932
2. Alternator
Controls System
Maintenance
Adjusting the Control
Handle Neutral Position
If the motion-control levers do not align or move easily
into the console notch, adjust the levers. Adjust each
lever, spring, and rod separately.
Note:
The motion-control levers must be installed
correctly.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Unlatch the seat and tilt the seat forward.
4. Begin with either the left or right motion-control
lever.
5. Move the lever to the neutral position but not
locked (Figure
6. Pull the lever back until the clevis pin (on arm
below pivot shaft) contacts the end of the slot
(just beginning to put pressure on the spring)
as shown in Figure
7. Check where the control lever is relative to the
notch in the console
Note:
Center the lever so that it pivots outward
to the N
EUTRAL
1. N - position
EUTRAL LOCK
2. Control lever
8. If adjustment is needed, loosen the nut and jam
nut against the yoke
65
92).
92.
(Figure 92).
- position.
LOCK
Figure 92
3. N position
EUTRAL
(Figure 93).
g001046