N/O Output With Error Signal; N/C Output With Error Signal - SICK TDR Betriebsanleitung

LFP Cubic

3.6 N/O output with error signal

Application
If there is an error message at the LFP, this can be transferred using a switching contact.
Configuration
Configure the Qx switching output as normally open
■
Set the parameter in the QxMENU-OUx menu to Qx_Eno
○
Select the electrical property [NPN/PNP/DRV (push/pull)]
■
Select the parameter in the QxMENU-TYPx menu
○
The following information applies:
○
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in push/pull function
▫

3.7 N/C output with error signal

Application
If there is an error message at the LFP, this can be transferred using a switching contact.
Configuration
Configure the Qx switching output as normally closed
■
Set the parameter in the QxMENU-OUx menu to Qx_Enc
○
Select the electrical property [NPN/PNP/DRV (push/pull)]
■
Select the parameter in the QxMENU-TYPx menu
○
The following information applies:
○
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in push/pull function
▫
8014825/YE12/2014-09-15 © SICK AG • Level sensors • Germany • Subject to change without notice
3 Configuring the switching outputs
EN
Operating instructions
83