Symbols; Parked Position; Safety Systems; Before Using For The First Time - Bosch myMUM MUM5 7S Serie Gebrauchsanleitung

en Before using for the first time
Hold the beating whisk at the bot-
6.
tom with one hand and tighten the
lock nut anticlockwise using a
spanner wrench.
5.7 Symbols
You can find an overview of the sym-
bols used on your appliance here.
Symbol Description
Marking on the protective
cover for drive 2.
Attachment marking on
the protective cover for
drive 3.
Position marking on
drive 3.
5.8 Parked position
Your appliance is equipped with an
automatic parked position.
After the appliance has switched off,
the drives will continue moving for a
few seconds until the correct parked
position is reached.
Note: The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct

parked position.

The following causes result in an
incorrect parked position:
¡ The power supply was interrupted
during processing.
¡ A safety system terminated pro-
cessing.
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 41
36
5.9 Safety systems
You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if
¡ the swivel arm is engaged in posi-
tion 1 and the bowl or an access-
ory is inserted, e.g. Ice maker.
¡ the swivel arm is engaged in posi-
tion 3 and the protective cover or
an accessory is fitted on drive 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
The motor will switch off if
¡ too large a quantity is processed.
¡ a tool or accessory is blocked.

Before using for the first time

6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Preparing the appliance
Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 37
⁠ .