Herunterladen Inhalt Inhalt Diese Seite drucken

Working With The Mortiser (Optional) - HOLZMANN-MASCHINEN K5 260L Originalbetriebsanleitung

5-fach kobination
Inhaltsverzeichnis

Werbung

14.7

Working with the mortiser (optional)

Setting the plan shaft cover so that the cutter shaft is completely covered.
A
B
E
D
C
HOLZMANN Maschinen Austria
All manuals and user guides at all-guides.com
Clamp Required milling tool with chuck (A) of the planer
- Place the workpiece on Langlochbohrtisch
- Workpiece clamping device (B) pivot rests to clamping foot in the
center of the workpiece
- Clamp the workpiece by pivoting the lever
-
Adjust table height handwheel (C) so that the cutting tool is posi-
tioned at the desired height on the workpiece
-
Lateral travel of the long hole drilling table with the two stop rods
(D) adjust
-
Switch the machine on the start button on the main switch
-
Move Langlochbohrtisch with control lever (E) to the left stop
-
Slowly press down on the cutting tool and workpiece up to the
max. Penetration depth of cut (depending on the milling tool)
-
Slowly swing control lever to the right and proceed to the stop
-
Repeat the process until the desired depth of cut is reached
-
Pull control lever back and move as workpiece from the cutting
tool away
www.holzmann-maschinen.at
5-fach Kombination / combined 5-operation machine K5 260L
OPERATION
Seite 53

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis