Safety Devices - HOLZMANN-MASCHINEN K5 260L Originalbetriebsanleitung

12.3

Safety devices

In the design of the machine following protective devices are provided:
 Restraint of the gap wedge. This measure is intended to prevent the return of the workpiece,
and the setting is in horizontal and vertical direction relative to the saw blade.
 Blade guard:
 The cap is mounted on the gap wedge to avoid contact with the blade.
 The blade unit can be submerged entirely under the workbench. This you have to remove the
cover from the gap wedge.
 Device for locking the setting selected in the vertical and horizontal direction and in an in-
clined position.
 Flanges for fastening tool. They are secured by a key on the shaft to the loosening of the
tools to avoid the stop of the machine.
 Nut (left-hand thread!) For mounting on the tool shaft. wells for Adjusting the scorer.
 Rip fence. Is used for precise guiding of the workpiece in the longitudinal cutting. He is also
made of destructible material (aluminum).
 The setting of the parallel ruler is possible without the use of tools, and the position is read
on a graduated scale.
 Switch. While the belt is changed, with the door open, the engine will not start.
 Electronic brake for electrodynamic braking of the motor. Secures the tool brakes in less than
10 seconds after the drive off.
 Impeccable sharpened tools.
 The use of blunt tools is not permissible due to kickback, overloading the machine and pro-
duce poor surface during processing.
 Red wire support. For cutting operation where less than 120mm are cut off, less than 120mm
distance right of the blade to the rip fence. Here the wood by hand carry, but with the red
wire support.
HOLZMANN Maschinen Austria
All manuals and user guides at all-guides.com
www.holzmann-maschinen.at
5-fach Kombination / combined 5-operation machine K5 260L
SAFETY
Seite 40