Quality From The Very Start - Brita MAXTRA+ Gebrauchsanleitung

II. Quality from the very start
To ensure that you get the best results from your BRITA water filter jug, please follow the
instructions carefully.
1 Cleaning instructions for your new BRITA water filter jug
before first use and after every water filter exchange
Funnel and jug
Dishwasher safe (max. 50 °C).
For best cleaning results, turn the funnel upside down and let tap water flow through the
valve for a few seconds.
If your BRITA water filter jug has been in contact with food that is likely to cause
discolouration (e.g. tomato ketchup, mustard) clean your BRITA water filter jug. To avoid
possible discolouration of your BRITA water filter jug, do not include it in a dishwasher
containing dirty crockery from such foods.
Please clean your BRITA Flow only by hand with cold or lukewarm water.
Lid with BRITA Meter
Before cleaning the lid in the dishwasher please remove the BRITA Meter from the lid.
Press the two tongues on each side of the BRITA Meter and tilt the BRITA Meter back
towards the handle cover for complete removal. The removed BRITA Meter must not be
washed in the dishwasher. Clean the removed BRITA Meter by hand.
Lid with non removable BRITA Memo
The lid must not be washed in the dishwasher. Clean the lid by hand.
BRITA water filter tank with a tap spout
Please pass warm water through the tap spout, and you may wipe it internally with a
cotton bud or similar. Please hand tighten the union nut in order to ensure that leaks are
prevented. The tap can be easily disassembled by screwing off the cap located under the
lever and then cleaning the spout and components.
Please use mild detergents but no abrasive cleaners. For descaling the
lid and the BRITA Smart Light use common household citric acid based
descaling fluids.
2 Preparation of the MAXTRA+ water filter
For quality you can trust: BRITA hot steam treatment for ultimate hygiene in every
MAXTRA+ water filter. Remove the protective wrapper from the MAXTRA+ water filter
(Note: The MAXTRA+ water filter may be damp from steam treatment process). Fill the
clean jug with cold water. Immerse the MAXTRA+ water filter in cold water and shake it
gently to remove any air bubbles. Remove the MAXTRA+ water filter and discard the used
water.
3 Insert the MAXTRA+ water filter
Insert the funnel into the jug. Place the MAXTRA+ water filter into the hollow of the funnel
and push downwards until it is positioned firmly.
4 Filling of the BRITA water filter jug
The filling method depends on the features in the lid of your BRITA water filter model. The
water in the funnel is automatically filtered and flows into the jug.
Variants of the lid
BRITA water filter with automatic pour through lid
If your BRITA water filter features a BRITA Meter please turn the lid on its back and insert
the BRITA Meter into the lid. Put the hook under the "START" button into its assembly jig in
the lid. Tilt the BRITA Meter forward until it "clicks" firmly into place.
A
M
B
D
C
E