Operation; Before Getting Started; Switching The Appliance On And Off En; Configuring Operating Mode - hanseatic HGS17260ENFI Gebrauchsanleitung

Operation

Before getting started

– Read chapter "Safety" from page EN-4, in
particular all the safety notices.
– Set up and connect the appliance as de-
scribed in chapter "Before starting to use
the appliance" from page EN-23.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the cooling unit to stand up-
■
right for two hours before start-up.
The lubricant will fl ow back into the
compressor during this time.
Switching on
1. Insert the mains plug in an easily accessi-
ble socket (see "Technical specifications"
on page EN-32).
The appliance is switched on.
– The compressor starts to work, the re-
frigerant flows through the pipes and a
quiet humming sound can be heard.
– All indicators will illuminate on the dis-
play for a few seconds.
– A few seconds later, the previously se-
lected temperature and operating mode
will light up.
2. If the appliance makes worrying noises,
check the solid base and remove any ob-
jects that may be on top of the appliance.
The appliance is checked for func-
tionality before being delivered. The
most recently made settings are
retained.
Operation Operation
Switching off
1. Disconnect the mains plug from the socket.
The compressor is switched off. The appli-
ance no longer refrigerates.
2. Empty the appliance and clean it (see
"Care and maintenance" on page EN-21).
3. Leave the appliance door slightly open to
prevent mould from forming.

Configuring operating mode

The appliance operates in freezing mode. It
can also operate in cooling mode.
1. Check the operating mode and tempera-
ture setting before using appliance.
Freezing mode is displayed on the control
panel's right side and the cooling mode on
the left side.
Freezing mode example:
No Frost
°C
8 -16
6 -18
4 -20
3 -22
2 -24
F R I D G E
FREEZER
Hold 3 sec.
The last freezing temperature setting used
illuminates on the control panel's right side
(temperature is set at −18 °C in the example).
2. To select the operating mode, press the
F R I D G E
button (11) for 3 seconds.
FREEZER
Hold 3 sec.
The last temperature setting used for the
newly selected operating mode illuminates.
Page EN-13