hanseatic HGS17260ENFI Gebrauchsanleitung Seite 61

In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our service de-
partment (see page EN-30).
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Do not kink or pinch the mains cable
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
When positioning the appliance, en-
■
sure the supply cord is not trapped or
damaged.
Do not locate multiple portable sock-
■
et outlets or portable power supplies
at the rear of the appliance.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and damage to prop-
erty.
Connect the appliance only to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
Start-up
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
The compressor starts to work, the refrig-
erant flows through the pipes and a quiet
humming sound can be heard.
You will find all important information
about operation from page EN-13.
Page EN-27