Installation Instructions; Safe Installation; Electrical Connection - Junker JG4119260 Gebrauchs- Und Montageanleitung

en Installation instructions
Cooking in combination with a microwave
Recommended settings for cooking with the microwave.
Food
Potato gratin
17 Installation instructions
Observe this information when installing the appliance.
17.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Never remove the transparent film on the
inside of the door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be temperature-resistant
up to 90 °C, and adjacent unit fronts up to
65 °C.
¡ Do not install the appliance behind a de-
corative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
48
Microwave Type of heating Cooking time
power setting
in W
360
Note:
in mins
35–40 Place a 22 cm diameter Pyrex
dish on the turntable.
WARNING ‒ Risk of injury!
Sharp-edged parts may be accessible during
installation.
▶ Wear protective gloves.
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
▶ If the power cord is too short, contact Cus-
tomer Service.
▶ Only use adapters approved by the manu-
facturer.
17.2 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING ‒ Risk of electric shock!
Incorrect installation is dangerous.
Only a qualified electrician may route the socket or
▶
replace a power cable while taking into considera-
tion the applicable regulations.
Connect the appliance only to a correctly installed,
▶
earthed socket.
If the plug is no longer accessible following installa-
▶
tion, an all-pole isolating unit with a contact clear-
ance of at least 3 mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.