Causes Of Damage; Installation And Connection - Junker JM15AA51 Gebrauchsanleitung

Causes of damage

Caution!
Heavily soiled seal: If the seal is very dirty, the appliance door
■
will no longer close properly during operation. The fronts of
adjacent units could be damaged. Always keep the seal
clean.
Operating the microwave without food: Operating the
■
appliance without food in the cooking compartment may lead
to overloading. Never switch on the appliance unless there is
food in the cooking compartment. An exception to this rule is

Installation and connection

This appliance is intended for domestic use only.
This appliance is only intended to be fully fitted in a kitchen.
Please observe the special installation instructions.
The appliance can be fitted in a 60 cm wide wall cabinet (min.
30 cm deep and 85 cm off the floor).
The appliance is fitted with a plug and must only be connected
to a properly-installed earthed socket. The fuse protection must
be rated at 10 amperes (L or B circuit breakers). The mains
voltage must correspond to the voltage specified on the rating
plate.
The socket must be installed and the power cable replaced by
a qualified electrician only. If the plug is no longer accessible
following installation, an all-pin disconnecting device must be
present on the installation side, with a contact gap of at least
3 mm.
Multiple plugs, plug bars and extension leads must not be
used. Overloading can result in a risk of fire.
a short crockery test (see the section "Microwave, suitable
crockery").
Microwave popcorn: Never set the microwave power too
■
high. Use a power setting no higher than 600 watts. Always
place the popcorn bag on a glass plate. The disc may jump if
overloaded.
Liquid that has boiled over must not be allowed to run
■
through the turntable drive into the interior of the appliance.
Monitor the cooking process. Choose a shorter cooking time
initially, and increase the cooking time as required.
Never use the microwave oven without the turntable.
■
17