Balluff BOS R254K-UUI-PR10-S4 Handbuch Seite 197

BOS R254K-UUI-PR10-S4
Photoelectric Sensors
6
System Functions (continued)
Namur Standard
LED 1 (operating state and communication)
Name
Failure
Communication
Ready Diagnosis On
Ready Diagnosis Off
Tab. 6-20: LED meaning and configuration – Balluff default, LED 1
LED 2 (Indication/Warning/Teach/Ping)
Name
Ping
Short Circuit Pin 2 / Pin 4
Teach In No Object
Teach In
Maintenance Required
Functional Check
Overload
Bad Signal Quality
Out of Specification
Function Display
Tab. 6-21: LED meaning and configuration – Balluff default, LED 2
6.6.2 ISDU
Name Index
LED 0x00FD (253)
Standard
Selection
Tab. 6-22: LED meaning and configuration – ISDU
www.balluff.com
Signal
Red, static
Yellow, alternating with
LED off in a ratio of 10:1,
1 s period
Green, static
White
Signal
Blue, flashing, 3 Hz
Red, flashing, 3 Hz
Red, flashing, 1 Hz
Red, static
Blue, static
Orange, static
Orange, flashing, 3 Hz
Orange, flashing, 1 Hz
Yellow, 3 Hz
Yellow, static
Subindex Access
0 R/W
Meaning
General error
IO-Link communication is active. The device is ready.
The device is ready. Diagnosis functions are on.
The device is ready. Diagnosis functions are switched off.
Meaning
The ping can be activated via a system command to find
the device again.
Short circuit at pin 2 or pin 4
The sensor is in Teach-In mode and no object is visible.
Teaching is not possible.
The sensor is currently in Teach-In mode
Maintenance must be performed.
The device is currently being parameterized/adjusted.
Measurement is not currently possible.
Overload on pin 2 / pin 4 has been detected.
The signal quality of the measurement signal is below the
warning threshold. A reliable signal can no longer be
ensured.
The device is operated outside of specifications. A
reliable measurement signal can no longer be ensured.
Light reception from reflector
Length Data Type
1 byte ENUM
Data Default
Storage
yes 0
english 93