Balluff BOS R254K-UUI-PR10-S4 Handbuch Seite 125

BOS R254K-UUI-PR10-S4
Photoelectric Sensors
3
Overview of IO-Link Data and Functions (continued)
Event Code Event Type
0x8D08 Warning
(36104)
0x8D09 Warning
(36105)
0x8D0B Warning
(36107)
0x8D0D Warning
(36109)
0x8D0E Notification
(36110)
0x8D10 Warning
(36112)
0x8D12 Warning
(36114)
0x8D13 Warning
(36115)
0x8D15 Warning
(36117)
0x8D20 Warning
(36128)
0x8D22 Warning
(36130)
0x8D23 Error
(36131)
0x8D24 Warning
(36132)
0x8D25 Error
(36133)
0x8DC0 Notification
(36288)
Tab. 3-4: Events – Overview
www.balluff.com
Description
Speed value is below the limit.
Speed value is above the limit.
Overload or short circuit at pin 2
► Check wiring.
Incorrect load/cable breakage, analog current output
pin 2
► Check wiring or connected devices.
The time has elapsed. This event reports the timeout
of the minimum value/maximum value/average
calculation.
It does not report a timeout for the calculation of the
moving average because the timer repeats and it
does not indicate the end of the calculation.
Device temperature upper warning – The set upper
temperature warning threshold has been exceeded.
The defined threshold of the device-internal humidity
was exceeded.
► Check installation and ambient conditions.
One or more extreme conditions present.
Overload at pin 2
► Check wiring.
Device temperature lower warning – The set lower
temperature warning threshold is below the minimum
value.
Warning limit for write cycles reached – maintenance
monitoring no longer guaranteed – for information
purposes only.
Write cycle limit reached – saving no longer ensured
– replacement recommended.
Parameter write error – for information purposes
only.
Parameters not consistent – basic settings are used,
service required.
Teach-in timeout – The current teach process took
too long and was interrupted.
Device Status
0 – Device is operating properly.
0 – Device is operating properly.
2 – Out-of-Specification
2 – Out-of-Specification
0 – Device is operating properly.
0 – Device is operating properly
1 – Maintenance-Required
0 – Device is operating properly.
2 – Out-of-Specification
0 – Device is operating properly
0 – Device is operating properly
1 – Maintenance-Required
0 – Device is operating properly
4 – Failure
0 – Device is operating properly.
english 21