Servicing - Falcon Classic Deluxe 110 Gebrauchs-, Installations- Und Wartungsanleitung

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Servicing

BEFORE SERVICING ANY GAS CARRYING COMPONENTS. TURN
OFF THE GAS SUPPLY
Check the appliance is gas sound after completion of service.
When checking for gas leaks do not use washing up liquid
- this can corrode. Use a product specifi cally manufactured for
leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before commencing
servicing, particularly before removing any of the following:
- control panel, side panels, hotplate tray or any electrical
components or covers.
Before electrical re-connection, check that the appliance is
electrically safe.
Note - References to LH and RH oven apply as viewed from
the front.
1 To Remove the Control Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove the 4
fi xing screws underneath the control panel.
Remove the handrail by removing the 2 end bracket fi xing
screws.
Remove the 2 cross-headed screws that were hidden by the
handrail end brackets.
The control panel should drop down slightly. It is held at the
top by two holes in the top edge one at each end that locate
on tags on the inner panel.
Clear the holes from the inner panel and pull the control
panel forward.
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads refer to the
wiring diagram. Check operation of timer.
2. To Remove Hotplate
Disconnect from electricity supply.
Caution
The ceramic hob material is much more sensitive to
scratches on the underside than the top.
Take care not to touch or scratch the underside of the
ceramic as this will weaken the material and cause the top
to shatter.
Remove the pan supports and burner heads. Remove the
screws holding the hotplate burners to the hotplate.
Remove the 6 screws and 2 studs holding the hotplate tray to
the cooker.
Taking care not to damage the burner electrodes, carefully lift
the hotplate, from underneath disconnect the earth lead at
the right hand rear from the rear cross member and withdraw
the hotplate.
Reassemble in reverse order ensuring that the leads are
reconnected. Take care not to damage the ignition electrodes
of the burners.
It is important that the rear earthing leads are replaced when
the fi xing screws are refi tted as they from part of the cooker
earthing.
Check for correct burner operation.
3. To Remove Side Panels
Disconnect from electricity supply.
Remove the Control Panel - see 1. Pull the cooker forward.
Remove the 4 retaining screws for each panel (1 at the front
base, 1 on the top and 2 at the rear).
Reassemble in reverse order.
4. To Remove light Switch
Disconnect from electricity supply.
Remove the Control Panel - see 1.
NB. The old switch may be destroyed during removal. Remove
the old switch from its bezel by griping the switch body
behind the control panel and twisting sharply. The switch
bezel can then be removed by folding back its locking wings
and pushing forward. Fit the new bezel to the control panel
by fi rst lining up the raised key on its body with the cutout in
the control panel and pushing it in from the front. Assemble
the new switch to the bezel by lining up the key sections and
53