Control Panel; Figure 12 Adapting The Arm Rests To The Forearm Length - Ottobock C1000 DS Gebrauchsanweisung

Operation
Adapting the arm rests to the forearm length
1. Loosen the two Allen head screws on the underside of
the arm rest using an Allen wrench size 3. Three set
screws must be loosened on the side where the control
panel is attached (see Figure 12).
2. Move the arm rest with the control panel holder or re-
placement tube forward or backwards to the desired
position along the attachment rail.
3. Retighten all set screws.
Figure 12 Adapting the arm rests to the forearm length
152 Ottobock
|

6.1.4 Control panel

CAUTION
Risk of accidents and injury due to uncontrolled move-
ments of the wheelchair. Before changing the position of
the control panel or installing/ removing it, turn off the con-
trol unit of the power wheelchair.
NOTICE
Cable damage. Positioning the cables incorrectly can
lead to pinching and damage to the cables. The cables
must not be attached too tightly or too loosely. Avoid bend-
ing or squeezing the cables.
Adapting the control panel to the arm length
The control panel is attached to a rail which is located be-
neath the arm rest.
1. Loosen the three set screws on the underside of the
arm rest using an Allen wrench size 3.
2. Move the arm rest with the control panel holder or re-
placement tube forward or backwards to the desired
position along the attachment rail.
3. Retighten all set screws.
C1000 DS