KONIFERA BW31000 Gebrauchsanleitung Seite 21

Installation procedure
WARNING: Important safety instructions. Follow all instructions, since incorrect installation can lead to severe injury.
Before installing the drive, remove any unnecessary cords and disable any equipment not needed for powered
operation.
Install the actuating member of a manual release at a height less than 1.8 m.
A horizontal distance of at least 0.4 m is to be maintained between the fully unrolled driven part and any permanent
object.
Prior to installation
● Carefully unpack the awning and dispose of the packaging materials by environmentally-friendly means.
● Beware of the sudden unfolding of any parts, especially the folding arms.
Choosing the right location
Suitable wall types: reinforced concrete walls, brick walls. The chosen wall must be suitable
to hold and maintain the awning. We will not be responsible for any damage to persons, to
the property and to the awning due to weak support of installation wall.
Pls make sure the height and position before installation
Picture 2 is the installation distance from awning to wall or ceiling.
②
Mounting of wall brackets
Remove the plate and the retaining screw of each wall
bracket. Turning adjusting screw with a hex key 6 mm in
otherwise clockwise. Measure the distance in Figure-3.
This distance must be greater than 40 mm, (when the
distance equal to 45 mm, the angle of inclination of
awning is 80 °). Must be the same distance for all wall
brakcets.
09030-BW31000.indd 21
Pls make sure the heigth before installation according to
the height of front bar (H) and
sunshine(α°). After open the awning, the height must up
to human so it can protect your head from hitting the
awning.
C
α°
L=2.5M
H+450mm
80°
75° H+650mm
70° H+850mm
H+1050mm
65°
60° H+1250mm
③
- 21 -
6
the angle of
Hex key
Pressing block
Adjusting bolt
04.10.18 20:08