Directing The Spotlight; Changing The Bulb; Dimming The Lamp; Maintenance And Cleaning - LIVARNO LUX 307291_1904 Montage-, Bedienungs- Und Sicherheitshinweise

Now drill the fixing holes (approx. ø 6 mm,
depth approx. 40 mm). Be careful not to
damage the supply line.
Insert the dowels
1
Fasten the mounting bracket
screws .
4
Feed the power cord (external)
cable guides .
9
Now connect the external lead of the light to
the mains cable (external)
nal block .
11
Note: Be sure to correctly connect each of the
individual wires of the mains connection cable
(external): live wire, black or brown = symbol L,
neutral wire, blue = symbol N, earth wire,
green-yellow = symbol
Now use the screws
the mounting bracket
Use a clean, lint-free cloth to insert the light bulbs.
Attach the suction cup
light bulb .
6
Carefully install the light bulb
Insert the GU10 light bulb by carefully turning
it in a clockwise direction for one half rotation.
Ensure that it is positioned correctly.
Your light is now ready to use.
Reinsert the fuse or switch the circuit breaker
back on.

Directing the spotlight

Only change the direction of the spotlights
when the light is switched off.
Allow the lamp to cool off completely.
Position the individual spotlights
base. The spots can be turned by approx. 340 °.

Changing the bulb

RISK OF ELECTRIC SHOCK!
First disconnect the light from the mains when replac-
ing the lamp. To do so, remove the fuse or switch
off the circuit breaker in the fuse box (position 0).
Only use lamps as specified in chapter
„Technical data".
into the bores.
with the provided
2
through the
10
using the termi-
10
.
to screw the light to
3
.
2
to the glass of the
7
in the socket.
6
8
by their
8
Start-up / Maintenance and cleaning
Allow the light bulb to cool off completely.
Use a clean, lint-free cloth to replace a bulb.
Remove the faulty light bulb by attaching the
suction cup to the light bulb
7
fully turning it in an anticlockwise direction for
one half rotation.
Insert the new light bulb by attaching the suc-
tion cup to the new light bulb
7
fully turning it in a clockwise direction for one
half rotation. Ensure that it is positioned correctly.
Reinsert the fuse or switch the circuit breaker
back on.

Dimming the lamp

The lamps are delivered with a light bulb that is
dimmable to 3 different levels.
Press the wall switch several times in quick
succession to set the desired brightness and
light colour.
The bulb starts at 100 % brightness if the light has
previously been switched off for more than 3 seconds.
The dimming levels of the light bulb are as follows:
100 % brightness = 3000 K
40 % brightness = 2500 K
10 % brightness = 2000 K

Maintenance and cleaning

RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains circuit before
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
RISK OF ELECTRIC SHOCK!
For electrical safety, never clean the light with
water or other liquids, or immerse it in water.
CAUTION! RISK OF BURNS - HOT
SURFACES!
Allow the light to cool completely.
and care-
6
and care-
6
GB/IE 17