Scope Of Delivery; Parts Description; Technical Data; Safety - LIVARNO LUX 307291_1904 Montage-, Bedienungs- Und Sicherheitshinweise

Scope of delivery

Check immediately after unpacking that the parts
are complete and that the product is in proper
condition.
1 LED Ceiling light, Model 14141106L /
14141206L
2 Screws
2 Wall plugs
2 Protective tubes
3 Light bulbs, GU10
1 Suction cup
1 Set of assembly instructions and instructions for use

Parts description

Wall plug
1
Mounting bracket
2
Screw (connection housing)
3
Screw (mounting bracket)
4
Terminal housing
5
Light bulb
6
Suction cup
7
Spotlight
8
Protective tube
9
Mains connection cord (external)
10
Terminal block
11

Technical data

Item no.: 14141106L / 14141206L
Operating voltage: 230–240 V∼ 50 Hz
Rated output: LED, GU10, 3 x max. 5 W
Lamps: LED, GU10, max. 5 W
Protection class: I
Socket: GU10
Protection type: IP20

Safety

Safety notices

Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
Always check the light, power supply, and mains
cable for damage before plugging it in. Never
use the light if it shows any signs of damage.
A damaged mains connection cable poses a
danger to life due to electric shock. In the event
of damage, repairs or other problems with the
light please contact the service centre or a qual-
ified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (see chapter "Technical
data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
Introduction / Safety
GB/IE 15