Preparation; Required Tools And Material; Prior To Installation; Start-Up - LIVARNO LUX 307291_1904 Montage-, Bedienungs- Und Sicherheitshinweise

Safety / Preparation / Prior to installation / Start-up
Prevent fire and
injury hazards
RISK OF INJURY!
Check each lamp and lamp glass for damage
immediately after unpacking.
Do not mount the light with defective lamps
and/or lamp lenses. In this case contact the
service centre for a replacement.
CAUTION! RISK OF BURNS -
HOT SURFACES!
Ensure that the luminaire has been switched off
and has cooled before touching it, to avoid burn
injuries. Lamps develop a lot of heat in the area
of the lamp head.
Allow the lamp to cool off completely.
Replace defective bulbs with new ones immedi-
ately. Before changing bulbs, always first re-
move the fuse or switch off the circuit breaker.
Do not leave the light or packaging material
lying unattended. Plastic film or bags, plastic
parts, etc. can be dangerous for children to
play with.
Lamp - use only in a dry environ-
ment.
This light is not suitable for external
dimmer and electronic switches.
Safe working
Only use lamps as specified in chapter
"Technical data".
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having diffi-
culty concentrating or do not feel well.
16 GB/IE

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / making tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (ø approx. 6 mm)
- Side cutting pliers
- Ladder

Prior to installation

Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Use the voltage tester to verify the de-energised
status.

Start-up

Mounting the light

Remove the screws
connection housing
ing angle from the back.
2
Use the slotted holes in the mounting bracket
intended for the screws to mark the bores.
visible at the side of the
3
and remove the mount-
5
2