Initial Use; Shortening The Led Strip; Installing The Led Strip - LIVARNO LUX IAN 292149 Bedienungs- Und Sicherheitshinweise

Safety / Initial use
Do not use the LED strip if it is covered with
objects or is inlaid into a surface.
Do not install the light on damp or conductive
surfaces.
This LED strip must not be connected electrically
with other LED strips.
Protect the product from sharp edges, mechani-
cal loads and hot surfaces.
Do not secure with sharp staples or nails.
Always unplug the mains plug from the socket
before assembly, disassembly or cleaning.
Never catch hold of the mains plug or the LED
strip with wet hands.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
This item must not be connected to the power
supply while it is still in its packaging. Lay out
the item completely before you connect it to the
power supply.
Prevent fire and injury
hazards
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced.
If the LEDs cease to function at the end of their
operational life, the entire item must be replaced.
The installed LEDs are not suitable
for dimmers or electronic switches.
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instrument
(e.g. magnifier).
Safe working
Install the light so that it is protected from dirt
and excessive heating.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never use the LED strip if you are having
difficulty concentrating or do not feel well.
14 GB/IE
Before use, familiarise yourself with all the
instructions and diagrams in these instructions,
as well as with the LED strip itself.
To completely disconnect the LED strip from
the power supply, the mains adapter must be
removed from the mains socket.

Initial use

Remove all packaging materials before first use.
Do not connect the LED strip to the mains while
it is still in its packaging or while it is rolled up.

Shortening the LED strip

The LED strip can be trimmed.
DANGER TO LIFE BY ELEC-
TRIC SHOCK!
Disconnect the lights from the power supply before
performing any work on the LED strip
the mains adapter from the socket to do so.
1
Choose the desired LED strip
Note Ensure that you cut the LED strip
the right place. The cutting point lies exactly be-
tween the plus and minus pole and is marked
with a black line (Fig. C).
Shorten the LED strip
Be sure to cover the open end of the LED strip
with the adhesive strip
2
Fig. E).

Installing the LED strip

Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Note: Ensure that a plug socket is located in close
proximity to the installation area.
Choose a suitable installation area (window
etc.).
Remove the protective foil from the reverse side
of the LED strip
2
. Unplug
2
length.
2
2
using a pair of scissors.
2
before use (see
6
(see Fig. B).
at