Inhaltsverzeichnis
Werbung
EX3™ Stepper
2. Tighten interface screws (2) by turning clockwise. If interface screws do not move freely, apply lubricant that complies with hospital policies or
procedures. Super Lube® Multi-Purpose Synthetic Grease with Syncolon
3. Rotate EX3 Stepper, place bottom cover over posterior section and tighten bottom hold screws (2) by turning clockwise. Ensure USB cord strain relief
groove is aligned with notch in cover.
4. Rotate EX3 Stepper. Place top cover over posterior section, aligning locating tabs on top and bottom covers.
5. Tighten hold screws (2) by turning clockwise.
6. EX3 Stepper is now assembled. Perform pre-use checks to ensure device is functioning properly.
ELECTROMAGNETIC COMPATIBILITY (EMC) PRECAUTIONS
NOTE:
EX3 Stepper needs special precautions regarding EMC and needs to be installed and put into service according to the EMC information
n
provided in this document.
Portable and mobile RF communications equipment can affect the EX3 Stepper. Recommended separation distances between the EX3
n
Stepper and RF communications equipment are provided in Table 4.
For EMC problems not described within this section, contact CIVCO at 319.248.6757, 800.445.6741.
n
®
(PTFE) is recommended.
I. Interface Screws
II. Posterior Section
III. Location Lock Finger
IV. Index Drum
I. Hold Screws
II. Top Cover
7
English
I. Bottom Cover
II. Hold Screws
Werbung
Inhaltsverzeichnis
