en
Operation
Predetermined breaking point
Fig. E:
The builtin predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the
continuousfeed shredder breaks. However,
the drive shaft can easily be replaced. A new
disc holder with drive shaft is available from
customer service.
Reversible cutting disc –
thick / thin
for cutting food into thick or thin slices, e.g.
fruit and vegetables.
Marking:
■ 1 = thick slices
■ 3 = thin slices
Note: Not suitable for processing hard
cheese, bread, rolls or chocolate.
Tip: Only cut up cooked potatoes once they
have cooled down.
Reversible shredding disc –
coarse / fine
for shredding food coarsely or finely, e.g.
fruit, vegetables or cheese as Gouda or
Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Fine grating disc
for shredding food finely, e.g. nuts or
hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
Working with the continuous-feed
shredder
Fig. F:
■ Press the Release button and
move the swivel arm to position 2.
28
■ Insert the bowl:
Tilt the bowl forwards and then set it down.
Turn anticlockwise until it locks into place.
■ Press the Release button and
move the swivel arm to position 3.
■ Remove drive cover from the drive
of the continuousfeed shredder
(Fig. F-5a).
■ Hold disc holder at the lower end, ensuring
that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. F-6a).
In the case of reversible discs, ensure that
the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. F-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuousfeed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. F-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuousfeed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove cover
from the continuousfeed shredder and
empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuousfeed shredder in an
anticlockwise direction and remove.
■ Rotate the lid in an anticlockwise direction
and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. G).
■ Clean parts.