Operation - MEISTER CRAFT MOF 1300 Originalbetriebsanleitung

5458060-Oberfraese-man 24.01.14 11:48 Seite 67
Fig. 7-21: Using 2 bolts and 2 nuts, fit
curve fence to the parallel fence. Loosen
grip screw (1). Adjust wheel (2) so that it
can run along halfway up the end face
of the workpiece. Firmly tighten knurled
screw.
Fitting centring point
Application example:
Routing circular
workpieces.
Fig. 7-22: Fitting parallel fence reversed.
Using the knurled nut, fit the centring
point to the parallel fence.
8 – Operation
Safety check
Before use check that the router head
and any fitted parts are securely seated.
Connecting to power supply
Before use check that the mains voltage
is correct and the mains supply is fitted
with suitable fuses (see „Technical Data").
Insert plug in socket: the router is now
ready to operate.
LED working light
When the unit is switched on, the
LED working light also comes on
to ensure better vision and to
make working in dark areas more safe.
The working light goes out when the
On/Off switch is released.
CAUTION! LED is laser class 1!
Do not look directly into the
laser as this may result in damage to
the eyes.
Switching on
Momentary operation
Fig. 8-1: Press ON/OFF button (1). The
router will start to run. The LED light will
go on.
Continuous mode
Fig. 8-1: Press ON/OFF button (1). The
router will start to run. The LED light will
go on. Press lock button (2) and release
ON/OFF button.
Regulating speed
Fig. 8-2: Setting the speed control
(1 = minimum, max. = maximum speed).
Tip: The brightness of the LED light
depends on the speed.
Switching off
After momentary operation
Fig. 8-1: Release ON/OFF button (1).
The router will stop. The LED light will
go out.
Risk of injury from still rotating
router head! Wait until motor
comes to a dead stop!
After continuous operation
Fig. 8-1: Press ON/OFF button (1). The
lock button will (2) release. Release ON/
OFF switch. The router will stop. The
LED light will go out.
67