Mettler Toledo IND780 Installationsanleitung Seite 29

IND780 Terminal Division 2 and Zone 2/22 Installation Manual
Install the Panel Mount enclosure by following these steps:
Cut an opening and holes in the panel or industrial enclosure as indicated in the
panel cutout dimensions shown in Figure 2-3 in inches and [mm].
Loosen and remove the eight, 8 mm shoulder nuts holding the backing plate to the
enclosure. The gasket should remain in position on the terminal. Figure 2-4 shows
two images of the enclosure, one with the backing plate removed to show the
gasket, the other with the backing plate installed.
Figure 2-4: Gasket on Enclosure (left) and Backing Plate Installed (right)
2-14
Figure 2-3: Panel Cutout Dimensions