HBM WE2111 Bedienungsanleitung Seite 40

Quick start
40
r.ENtry menu item: Choose between OFF (default set-
ting; you can call FULL setup mode from the front panel)
and On (you must press the setup push-button on the rear
of the device to call FULL setup mode). The procedure for
making the setting is described below.
If the pass code is lost, the device must be sent in to HBM.
Then all settings will be deleted.
Procedure for setting the pass code
The settings are only possible in FULL setup mode.
 Press the
would like a setting to ensure that FULL setup mode can
only be called by pressing the rear push-button, you must
call Setup mode using the rear push-button, not with the
key.
SAFE is displayed.
 Press the
FULL is displayed.
 Press the
The display alternates between SEtUP, the firmware
version (for example P60c), the calibration counter (for
example C00008) and buiLd.
 Press the
SPEC is displayed.
key and hold it for several seconds. If you
key again (briefly).
key.
key 5 times.
A3603-2.0
WE2111