Maintenance; Cleaning; Replacement And Wearing Parts; Replacing Internal Batteries - Bosch BAT 171 Betriebsanleitung

en 20 | BAT 171 | Maintenance
6.

Maintenance

6.1

Cleaning

Only use a soft cloth and neutral detergents to clean
the housing and display of the BAT 171. Never use
abrasive cleaning agents or coarse workshop cloths.
6.2

Replacement and wearing parts

Designation
Printer paper (1 roll) (<)
(minimum order 5 rolls)
(<)
Battery connecting cable
(with battery clips)
(<)
Internal batteries
(6 x AA 1,5 V Mignon LR6)
(<)
Wearing part
(<)
6.3

Replacing internal batteries

i
If the internal AA batteries are in need of
replacement, the BAT 171 displays the message
"LOW INTERNAL BATTERIES! REPLACE BATTERIES
SOON!".
1. Use a small Phillips screwdriver to remove the screw
in the battery compartment cover on the back of the
BAT 171.
2. Remove the battery compartment cover.
3. Take out the flat batteries.
4. Fit new batteries.
!
In doing so pay attention to correct positive and
negative polarity (refer to symbols in battery
compartment).
5. Fit the battery compartment cover and secure it with
the screw.
|
1 689 989 061 2009-10-16
6.4
1. Remove the screw.
Order number
1 681 420 028
1 684 437 007
–
2. Hold the housing and pull the battery connecting
cable out of the housing.
3. Move the new battery connecting cable to the
correct position and insert.
4. Secure the battery connecting cable again.

Replacing battery connecting cable

Robert Bosch GmbH