Installation
Installing user modules
The remote console is connected to the
computer connected to the computer module can be operated from this console.
Establishing a connection to a local management network
Network Management:
ble as accessory. Connect the other end of the cable to the local network.
NOTE:
If desired, connect this network interface to a local network. This enables
you to access the
log messages to this network.
Connecting keyboard and mouse of consoles
NOTE:
Both the keyboard and the mouse of the console can either be PS/2 or USB
devices.
Keyb./Mouse:
Connect the mouse and/or the keyboard of the console to this interface.
Generic:
In the default settings, you can use this interface to connect another USB
input device, a supported display or tablet, or USB mass storage device.
Activate the
generic USB
USB« mode on page 49) if you want to connect another USB input device or USB
mass storage device. In this mode, any data of the USB device is not altered when trans-
mitted to the computer module.
IMPORTANT:
If the
keyboard connected to the
11 · G&D DP-Vision-IP-Fiber
Insert a category 5 twisted pair cable (or better), which is availa-
Config Panel
web application from this network and to send sys-
mode (see (De)Activating an USB keyboard mode the »Generic
generic USB
mode is active, the OSD cannot be operated by a
Generic
socket.
DP-Vision-IP-Fiber-CON
user module. The