Adjusting The Cutting Height; During Operation; During Operation Safety - Toro TimeMaster 76 cm Bedienungsanleitung

Adjusting the Cutting Height

CAUTION
If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Note:
To raise the machine, move the front and rear cutting-height levers forward; to lower the machine,
move the cutting-height levers rearward. Set all the wheels to the same height unless special circumstances
require otherwise; refer to

During Operation

During Operation Safety

General Safety
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
The blade is sharp; contacting the blade can result
in serious personal injury. Shut off the engine,
remove the ignition key (electric-start model only),
Operating Tips (page 19).
Figure 13
and wait for all moving parts to stop before leaving
the operating position.
•
When you release the blade-control bar, the
engine should shut off and the blade should stop
within 3 seconds. If not, stop using your machine
immediately and contact an Authorized Service
Dealer.
•
Keep bystanders out of the operating area. Keep
small children out of the operating area and under
the watchful care of a responsible adult who is
not operating the machine. Stop the machine if
anyone enters the area.
•
Always look down and behind you before moving
the machine in reverse.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Avoid mowing in
wet conditions.
12
g224172