Data Transfer; Delete All Channels - Triax DVB S2 Bedienungsanleitung

Remove Satellite TP Information
Move to the TP information you want to delete.
Press the LEFT button. A message asking for your confirmation asking for your confirmation
appears.
If you want to delete, press the OK button. Otherwise, press the BACK button or the EXIT
button.

9.9 Data Transfer

This is intended to transfer the channel information on one
receiver to another receiver of the same model / version.
You can also transfer channel information from your PC to a
receiver.
Receiver to Receiver (Set to Set)
Use a RS232C cable (cross type, "0-modem") to connect
both receivers.
Go the Main Menu, select "Channel Manager" and then
select menu option "Channel Data Transfer".
Select "3.MASTER (Set to Set)" for the receiver that will send
the channel data.
Select "4.SLAVE (Set to Set)" for the receiver that will
receive the channel data.
Press the OK button on both receivers to start the transfer.
"Sending" appears on the sending receiver and "Receiving" appears on the receiving
receiver.
The transfer progress bar shows the progress of the channel data transmission. When the
transfer is completed, "Complete" appears.
You can check that the channel data on the Slave and Master receivers are the same.
PC to Receiver (PC to Set)
You will need suitable software to be able to transfer the channel information from a receiver to
your PC and vice versa. This software will be provided upon request.
Please visit TRIAX website www.triax.com
Use a RS-232C cable (cross type) to connect the Receiver to your PC.
In your PC programme set your PC as "MASTER (Set to Set)". "MASTER" signifies the device
that is transmitting the channel information.
On the receiver go the Main Menu, select "Channel Manager" and then select menu option
"Channel Data Transfer".
Set your receiver as "SLAVE (PC to Set)"
Follow the instructions on the PC program to complete the rest of this process.

9.10 Delete all Channels

This function will delete all channel data from the receiver.All other individual settings
will be kept.
Go to the Main Menu, select "Channel Manager",and select "Delete All Channels".
Enter password upon request
A warning message appears.
Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears. Make your language selection and press OK.
Follow the instructions on the screen: either load pre-programmed channel data or start your
individual channel search process.
Cable Pin Configuration
(1) o --------- o (4)
(2) o --------- o (3)
(3) o --------- o (2)
(4) o --------- o (1)
(5) o --------- o (5)
GB