Usals - Triax DVB S2 Bedienungsanleitung

Select "Set-up Limit" and then press the OK button.
Select "Move East/West". Use the
antenna to the East Limit position.
Select "Set East Limit" and then press the OK button to
save the East Limit you have set previously.
Select "Move East/West" again. Use the
the antenna to the West Limit position.
Select "Set West Limit" and then press the OK button to
save the West Limit you have set previously.
Notes:
To disable the movement limits, select "Disable Limits" and then press the OK button.
To position the antenna at the center, select "Go to Reference" and then press the OK button.
Once the limits are set, locate the reference satellite.
From the "Antenna Positioner" screen, select "Select Satellite" and then use the
to select the satellite.
Select "Nudge East/West" and then use the
Find the position where the Signal is strongest.
When doing this, if the position of the antenna is well away from the target satellite, use
"Move East/West" in "Set-up Limit" to move the antenna first.
GB
Alternatively, select "Nudge East/West" and then use the
Each time you press either button, the antenna will automatically find the satellite.
Once the satellite is located, select "Store Satellite" and then press the OK button.
The position of the satellite is stored.
Notes:
If you select the stored satellite, the antenna moves in the direction of the satellite's position.
After locating a satellite, perform "Recalculation". This enables you to locate another satellite
automatically by using the currently selected satellite as a reference point. However, this only
provides an approximate position, so you will need to fine-tune the search.
Select "Recalculate Position" and then press the OK button.
When the message asking you to confirm your selection appears, press the OK button.
Notes:
Satellite Positions are stored in the "Antenna Positioner". Therefore, you will need to manually
set the position of satellites that the "Antenna Positioner" does not currently support.

9.5 USALS

This convenient function locates the desired satellite by USALS if latitude/longitude of the
receiving place and satellite longitude are known.
Move to USALS mode by using the
menu.
Move to "Auto Search" or "Manual Search" to search the desired channel in USALS mode.
Click the DiSEqC item in the Auto Search Menu to open the USALS Setting Popup Menu.
Enter the user location latitude and longitude. Use numeric keys to enter values. Use
buttons to convert East and West.
Enter the latitude and longitude of the desired satellite. Use numeric keys to enter values. Use
- buttons to convert East and West.
Click Store to save the input information. The antenna will direct itself towards the computed
USALS result.
If it is physically impossible to direct the satellite, an error will be displayed. Press the "Back"
key and enter new information if this happens.
Use the Signal Strength Bar to check if a satellite signal is received from the new antenna
direction.
Use Nudge East/West or Go to Reference to help the antenna work.
button to move the
button to move
buttons to move the antenna.
buttons to move the antenna.
buttons at the DiSEqC item in the "General Settings"
buttons
-