Cleaning The Appliance; Tips For Saving Energy - CONSTRUCTA CK 142401 Gebrauchsanleitung

en

Cleaning the appliance

1. Attention: Pull out the mains plug or
switch off the fuse!
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with tepid rinsing
water. The rinsing water must not get
into the temperature selector or
light,Fig. 2.
4. After cleaning: reconnect and switch
on the appliance.
Achtung: Nie das Gerät mit einem
Dampfreinigungs Gerät reinigen!
Steam may come into contact with
electrical components and cause
a short circuit or an electric shock!
The steam may damage the plastic
surfaces.
Do not use abrasive or acidic cleaning
agents and solvents.
Regularly clean the condensation channel
and drainage hole, Fig. 3, so that the
condensation can flow out. Clean the
condensation channel with cotton buds,
etc.
The rinsing water must not run through
the drain hole into the evaporation pan.
Attention!
Never clean the shelves or containers in
the dishwasher. The parts may warp!
26

Tips for saving energy

S Install the appliance in a dry, well
ventilated room, but not in direct
sunlight and not near a heat source
(e.g. radiator, cooker, etc.). If required,
use an insulating plate.
S Allow warm food and drinks to cool
down before placing in the appliance!
S When thawing frozen products, place
them in the refrigerator. The low
temperature of the frozen products
cools the food in the refrigerator.
S Open and close the door as briefly as
possible.
S A layer of hoarfrost in the freezer
compartment will impair refrigeration of
the frozen food and increase power
consumption. Defrost the appliance if
frost forms!
S Ensure that the freezer compartment
door has been closed properly.
S Occasionally clean the rear of the
appliance with a vacuum cleaner or
paint brush to prevent an increased
power consumption.