CAMPAGNOLO Neutron Ultra Bedienunganleitung Seite 36

• Unscrew and remove the lock ring (C - Fig. 24), press
the axle (G - Fig. 24) towards the hub body, remove
the ring (F - Fig. 24), the cone (H - Fig. 24), slide out
the axle (G - Fig. 24) from the hub, remove the cone
(I - Fig. 24), the gaskets (J - Fig. 24) taking care not to
damage it and the ball bearings (K - Fig. 24).
• If it is necessary to replace the cups, contact a
Campagnolo Service Center.
®
• Proceed to refit the system performing disassembly
operations in reverse order.
Attention
When inserting the axle, be careful not to move the ball
bearings out of their seats.
• Tighten the locking nut (B - Fig. 25) to a torque setting
of 12 N.m - 8.8 lb.ft.
• Adjust the hub as illustrated in section 7.
24
C F J H K
25
B
12 N.m - 8.8 lb.ft
K J I G
15