Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Remove the spoke (A - Fig. 18).
WARNING!
If necessary, first lift the spoke overlapping the one to be
replaced and, after assembly of the new spoke, make sure
it is returned to exactly the same position.
• Insert the new spoke in the hole in the rim.
• Fit the plate on the spoke, keeping the concave part
facing outwards and position it in the special groove on
the rim; when fitting a spoke on the LH side of the wheel,
the long side of the plate must face leftwards and vice
versa, as illustrated in figure 19.
• Tighten the nut (Fig. 19).
WARNING!
When fitting the wheel, check that the plates remain in
position since an incorrectly positioned plate may cause
irreparable damage to the profile of the rim when ten-
sioning the spokes. This damage could cause the rim to
unexpectedly fail, resulting in an accident, personal injury
or death.
12
18
A
19
Werbung
Inhaltsverzeichnis
